NAIL POP

이전

Printer User Guide

Printer User Guide
Device User Guide

Printer User Guide

Press the Printer UI Guide Button

Printer UI Guide

How to replace Cartridge #1

Please open the top cover
as below drawing.

How to replace Cartridge #2

Please put the cartridge
into the printer as below drawing

How to replace Cartridge #3

Insert the red part of the top cover into the groove and
slide it to the right to close it

닫기

Printer UI Guide

1Power button

Hold the button for 3 sec to on and off.

2System LED

Initialize

Scene	Status LED (RGB)	Note
System initializing	Gradient change	2 sec interval, continuous
System initialized (Idle)	Static
Bluetooth not initialized	Gradient change	1 sec interval, continuous
CP Chip not initialized	Gradient change	1 sec interval, continuous
TPH not initialized	Gradient change	1 sec interval, continuous

Battery

Scene	Status LED (RGB)	Note
Normal	Static	Over 30%
Low		5~20% / 3 sec interval, continuous
Very Low		Under 5% / 2.5 sec interval, continuous

Temperature(TPH)

Scene	Status LED (RGB)	Note
High Temperature	Gradient change	TPH Temp is over 55℃ / 1 sec internal, continuous
Low Temperature	Gradient change	TPH Temp is Under 5℃ / 1 sec internal, continuous
The temperature is OK	Static

Cartridge status

Scene	Status LED (RGB)	Note
Cartridge is loaded	Static
Cartridge is not loaded	Gradient change	0.5 sec interval 1 time, continuous

Bluetooth

Scene	Status LED (RGB)	Note
Sending image	Gradient change	2 sec interval, continuous
Sending Firmware	Gradient change	2 sec interval, continuous

Printing

Scene	Status LED (RGB)	Note
Preheat	Gradient change	2 sec interval, continuous
Cooling	Gradient change	1 sec interval, continuous
Printing Yellow	Gradient change	1 sec interval, continuous
Printing Magenta	Gradient change	1 sec interval, continuous
Printing Cyan	Gradient change	1 sec interval, continuous
Printing Gold	Gradient change	1 sec interval, continuous
Printing Sliver	Gradient change	1 sec interval, continuous
Overcoating	Gradient change	1 sec interval, continuous

Firmware update

Scene	Status LED (RGB)	Note
2 sec interval 1 time, continuous	Gradient change	2 sec interval 1 time, continuous
Firmware update complete		Reboot right after complete F/W update
Firmware update failed	Gradient change	1 sec interval 1 time, repeat 3 sec

ETC

Scene	Status LED (RGB)	Note
Paper Jam	Gradient change	1 sec interval, continuous
Ribbon Empty		3 sec interval 1 time, continuous
Media Feed error	Gradient change	1 sec interval 1 time, repeat 3 sec
EEPROM error	Static

3Reset button

4Charging LED

Need to charge

Charging

Full Charge

5USB-C Port